Accessories

Dispersetech manufactures a wide selection of quality mixer and tank accessories. Blades, shafts, hubs, and tank covers are among some of the items offered.

Accessories There are 9 products.

Showing 1 - 9 of 9 items
  • With the speed of the dispersion blades, typically, a set of tapered reinforcing plates is required on most dispersers to prevent blade flexing. These plates can be fit with the driving pins for blades with pinholes. As with all our blades it can be bored to fit any of the popular dispersers, including; Myers, Cowles, Hockmeyer, Schold, Shar, etc.

    $396.00
  • The 3/8" x 12" light-weight shafts is designed for chucks which will not accomodate the heavy-duty standard shaft or are for use with lab air motors with sleeve attachments. The shaft is designed for blades with a 1/4" center bore. (adapter is available for 1/2" bore) WARNING: Shaft may bend if blade is not immersed in fluid when mixer is turned on.

    $92.00
  • The 5/16" x 12" light-weight shafts is designed for chucks which will not accomodate the heavy-duty standard shaft or are for use with lab air motors with sleeve attachments. The shaft is designed for blades with a 1/4" center bore. (adapter is available for 1/2" bore) WARNING: Shaft may bend if blade is not immersed in fluid when mixer is turned on.

    $85.00
  • The 5/8" x 12" Heavy Duty shafts is designed for chucks which will not accomodate the heavy-duty standard shaft or are for use with lab air motors with sleeve attachments. The shaft is designed for blades with a 1/2" center bore. Chuck end cut down to 1/2" WARNING: Shaft may bend if blade is not immersed in fluid when mixer is turned on.

    $138.00
  • Hubs are used to add a scond disperser blade above the primary blade. They can also be use to add a blade to the end of a shaft that is not configured to mount a standard disperser blade. The bolted hub is separate from the blade and can be re-used, allowing future blades to be secured much as you would with a standard disperser.

    $0.00
  • Disperser Blades can be split, cut in two pieces, to allow large blades to fit in smaller tank openings, or to allow installation when obstacles are present.

    $0.00
  • Hubs are used to add a scond disperser blade above the primary blade. They can also be use to add a blade to the end of a shaft that is not configured to mount a standard disperser blade. The welded hub is an integral part of the blade and must be replaced as blades are replaced.

    $0.00
  • Reduce fumes and vapors leaving your dispersion tank. Keep foreign material from falling in your batches. Avoid lifting large heavy lids onto your tanks. The Floating Lid assembly is mounted to your high speed disperser. Guide rods raise the lid to allow tanks to be placed under your mixer and hold the lid when no tank is in place. Lid can be used with...

    $0.00
  • Blade covers protect your operator from accidental injury when your high speed disperser is not in use. Standard sizes are available 4" - Covers lab blades up to 4" diameter 8" - Covers blades from 5 - 8" diameter 12" - Covers blades uo to 12" diameter CustomBlade Guardsare available for larger blades. *NEVER operate machine with blade cover in place.

    $36.00
Showing 1 - 9 of 9 items
Prestashop Appliance - Powered by TurnKey Linux